END OF LINE
BE/AD
|
|
| |
|
|
|
|
|
Deflagration Flame Arrester, End-of-Line |
The PROTEGO® BE/AD end-of-line deflagration flame arrester provides protection against atmospheric deflagrations. The device is usually installed on vent lines of small vessels and plant equipment which are not pressurized. For safe application, it is important that an endurance burning situation can be excluded. So typically, it is installed on vents lines which discharge vapor for a short time period. The device is the ideal solution for preventing flame transmission from atmospheric deflagration into the vessel or plant.
The PROTEGO® BE/AD consists of the housing (1), a weather hood (2), and the PROTEGO® flame arrester unit (3). The device is equipped with a metal weather hood. The FLAMEFILTER® gap size will depend on the device’s intended use. Specifying the operating conditions, such as the temperature, pressure, explosion group, and the composition of the fluid, enables PROTEGO® to select the best end-of-line deflagration flame arrester for your application. The PROTEGO® BE/AD series endof- line deflagration flame arrester is available for substances from explosion groups IIA to IIC (NEC groups D to B).
The standard design can be used with an operating temperature of up to +60°C / 140°F.
Type-approved in accordance with the current ATEX Directive and EN ISO 16852, as well as other international standards. |
 Αποθηκεύστε τις Τεχνικές Προδιαγραφές
|
| |
|
|
|
|
| ΕΚΔΗΛΩΣΗ ΕΝΔΙΑΦΕΡΟΝΤΟΣ |
|
|
|
|
|
| |
|
|
| |
|
|
|
|
|
|
|
| |
επόμενο προϊόν 
|
| |
|
| |
Φλογοφράκτες
Βαλβίδες Εξαερισμού
Εξοπλισμός & Υλικά Δεξαμενών
|
